Witura WT9002 Manual do Utilizador descarregar pdf (Página 10)

WT-9002 IP65 User Manual

WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

The unit can be programmed up to 1000 phone numbers to become as authorized users.

The system will respond or answer to the call of authorized users only and reject

unauthorized calls.

The unit has 2 outputs which can be used as output. The outputs are connected to an

on-board relay

There are 2 output relays which can be activated by the person called via the keypad on

the mobile phone or landline phone. The output relays are both set at factory default to

latch for 1 second but can be programmed to latch on for up to 65,535 seconds. The

function for Relay 1 is accessible by 1000 programmable authorized users. Relay 2 can

only be activated or programmed by the 3 chosen administrator numbers.

The unit can operate in one out of two operation modes: Automatic or Password

Automatic Mode

If Automatic Mode is chosen (*TEL?#1, *ANY?#1), the unit will not answer any

incoming calls including administrators number and will operate the relay output (Relay

1) automatically Without Incurring Cost of Call

Password Mode

If Password Mode is chosen (*TEL?#0, *ANY?#0), the unit will answer any incoming

call immediately and indicate it by a short “Beep”. The unit will wait for a valid 6 digits

pin code to be keyed in by the caller. If the pin code is correct, the caller can access to

operate the output relay according to the function chosen. The unit will confirm by one

short “Beep” a correct pin code entered and three “Beep” if it is a wrong pin code

number.

iv) OUTPUT

vi) OPERATION MODE

v) RELAYS

iii) MEMORY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Sem comentários

Witura WT9002 Manual do Utilizador Página 10