Witura WT-1011RC IP 65 Manual do Utilizador descarregar pdf (Página 11)

WT-1011RC IP65 GSM Remote Controller

And Alarm S

stem

WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

Text Command:

*BOOK#nnXXXXXXXX

nn stands for the position number 00 - 99

XXXXXXXX stands for last 8-digits of a phone number

Example:

To program phone number 1234567890 as Guest into the list, you would send the

following SMS command to the unit.

*BOOK#0034567890

Example of Returned Message:

#WHL00-OK

The WT-1011RC has 2 outputs that are connected to an on-board relay. Each output

relay can be operated independently.

Output Relay 1

can be switched ON for a preset time with Caller ID as it can recognize

the incoming number, if it is an authorized user in the Administrator list it will reject the

call without answering and switch on the device connected to it.

Output Relay 2

can be switch on for a pre-determined length of time by a simple text

message.

This command allows you to reset the default latching time of relay. To reset the default

value, you can send the following text command via SMS specifying the number of

seconds the output relay 1 should stay on when it is called. It is possible to set up to

maximum of 65,535 seconds. Default: 1 second

Text Command:

*GOT1#XXXXX

XXXXX stands for 5 digits value: The number of seconds

Example:

To set the output relay 1 to stay on for 15 minutes each time it is called, you would send

the following command to the unit.

*GOT1#00900

5.4 OUTPUT Settings

5.4.1 Reset the Default Latching Time of Relay 1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Sem comentários

Witura WT-1011RC IP 65 Manual do Utilizador Página 11